Although the lifting platform is a high-altitude operation equipment, there will still be some small amplitude movements during the lifting operation. In fact, slight shaking is allowed after the lifting platform is lifted. However, if the amplitude exceeds the limited range, it indicates that there is a problem with the lifting platform, and the operation needs to be stopped immediately for inspection. Next, we will show you how to solve the shaking during the lifting platform operation.
1、 The shaking amplitude of the lifting platform is in direct proportion to its own lifting height. The higher the lifting height, the greater the shaking amplitude. Before the lifting operation, the lifting platform must fully open the four supporting legs, ensure that the four supporting legs are in full contact with the ground, and try to place the lifting platform on a flat and solid ground for operation.
2、 Operators shall try their best to work in the middle of the table top. If goods need to be placed, the load difference between the two sides of the table top shall be minimized to prevent bias load. When working outdoors, if the wind force is too large, the operation shall be stopped.
3、 The frame structure of the lifting platform is damaged and deformed. This kind of situation is very serious, but it is rare. In this case, the manufacturer can only be contacted for after-sales maintenance. In addition, there will be a gap between the pin shaft and the bearing after a long time of friction, resulting in overall shaking.
In short, the shaking within the safe range will not affect the high-altitude operation of the lifting platform, and everyone can use it with confidence. If the shaking is too large, it should be stopped immediately and can be put into use after the fault repair is completed.
